Hydraulic Press Brakes

Cap: 20 T to 400 T, Length 1500 to 4000 mm.

Application: Sheet Bending forming punching embossing.

Design of Operating Features of Hydraulic Press Brakes

• Mono block welded steel frame ultra tested 2062 steel plates rigid to provide accurate bending
• All pivots have hardened of ground pin bushed of give piece guide slide lubricated by central hand pump
• Repetitive accuracy is within ± 0.03 mm
• Ram travel parallelism with out using sensitive and complex servo Hydraulics
• Most reliable hyd. components and sealing for international reputed design for 350 bar against operating pressure of 160 bar maximum
• Three cycles operation inch single cycle and auto for grater operator convenience
• Three speed operation reduces ideal travel time which improves productivity
• Bending force easily adjustable from front for fregue tools of bending soft material
• Movable operator console is provided with switches for cycle selection ram up down travel emergency stop and motor on/off
• Manual backstop with micro adjustable swing stop facilitate reverse bend
• Electrical panels and components are provided as per international reputed brands
• Precisely designed of manufacture cylinders provided unlimited trouble free life. Seals can be changed quickly without dismantling the ram or need of crane.

Standard Features and Accessories for Hydraulic Press Brakes

• Main drive standard make motor
• Electrical control panel with three speed inch, Single cycle, Auto mode of operation
  
• Two front sheet supports
• Manual back gauge with micro adjustment swing stoppers
• Pair of lifting chains
• Fine stroke adjustment rod with limit switches
• One suitable 5 way die and blade Segmented or full length, EN 9 not covered under warranty
• Movable console with emergency stop
• tonnage indicating adjustment device
• Manual centralized lubrication system with hand pump
• Bending chart.

Optional Accessories

• Ram tilting arrangement
• Motorized back gauge with DRO
• Extra finger for standard back gauge
• Automatic lubrication system
• Extra depth of throat.

Bending capacities stated are only representative and not binding allow extra capacity for material inconsistencies, bending condition. Right to change specification features without notice reserved.